This video will show you how to replace the third brake light lens and bulbs on a 1995-2003 Ford Ranger
This video will show you how to replace the front brake pads and rotors on a 1995-2002 Ford Ranger
This video will show you how to replace the EGR pressure feedback sensor on a 2001-2002 Ford Ranger
This video will show you how to install a serpentine belt on a 2001 Ford Ranger
This video will show you how to replace the lower radiator hose on a 2001 Ford Ranger
Forum Thread: How to Do I Locate the Fuse That Controls the Wind Shield Wipers in a 2010 Chevy Malibu LT?
This would be very helpful for myself and others in determining the possible causes for malfunctioning .
My husband needs to replace the fuel pump in a 1987 V10. It has dual tanks. Not sure if this means it has dual pumps. I cannot find a helpful video anywhere. How do we remove the bed to replace the fuel pump? Its a 1987 V10 Chevy Silverado. We found this problem when we replaced the battery, it would turn over but not start unless we sprayed starter fluid on the carbuerator. Once he gave it gas, it would die. Help!
Forum Thread: How to Join 2 Copper Tubes(Same Dia and Different Dia) Using Any Adhesive or a Sealant?
Need to join 2 copper tubes (same & different dia). Refrigerant gas flows inside with 10 Degrees or less. Sealing must not let any gas pass through.
Put on fender 1995 Sao coup. Sc1
The headlights on the truck go off and on once I turn them on. I have replaced the light switch and the dimmer switch as well.
I am going to remove the old transmission and install a new one. I have never done this with a front wheel drive and I would a step by step on how to do this. I Checked our the guide and it is not very forth coming with complete details
Have no Cadillac converter on 1999 Chevy S10 engine light stays on, can I wire lines together that's going to the sensor have 2-brown wires 1-white wire 1-purple wire or how can I stop the light from being on
Lost key to 2001 Saab SE. $500 cheapest quote I got for a new key and to reprogram the TWICE module. That's if I bring them the module. If they have to take it out themselves: $1000. Under the seat somewhere, I think you have to remove the seat, which is welded in place and then put it back. Saab security system. Overkill. Anyone know any hacks?
I hear water rolling around and draining, but I don’t see any water?
How can the nisssan navigation maps for a 2011 armada and 2013 altima be updated without paying the dealer $150?
I'm Trying to Install a Water Proof Heavy Duty Quick Ada
I want to make sure I use the correct type.
Hello, could you tell me how to replace front left fender 97 grand prix and inner liner with attachment hardware part numbers?
Forum Thread: 2006 Nissan Altima,a/C Leaks Water into Rear Passager floor.where Is the Drain for the a/C.
Step 1: Water Leak on Rear Passages Floor.
I need to replace it.
I'm a military mechanic, so I have a good knowledge of basic mechanics. My son has a '98 Chevy Lumina that keeps blowing fuel pump fuses. I know there is a short in the system causing this to happen. It started a few days ago, he was making a left hand turn and it blew. We replaced the fuse, that one blew also after a turn into a parking lot. He replaced it again and it didn't blow for a day or two, now it's blowing every time when he tries to start. That being said, my question is this, on t...
Hi! I Have a 90 Honda Civic Wagon. The Second Spark Plug Boot Repeatedly Pops Up. The Spark Well Collects Some Oil and Water Which Causes Misfire (Even Has Just Run on 3 Cylinders). I Have Replaced Those O-Ring Seals Underneath the Rocker Assembly Several Times but the Problem Always Comes Back. How Does This Keep Happening? Its Got Great Compression and the Top of Engine Has Been Rebuilt. Also Have New Distributor Plugs,Wires/Cap. Where Does the Moisture Come from and Why Only in the Second ...
I changed battery recently and my speedometer stopped working and I am wondering if that's what caused it by putting in a new battery
When you start the engine in park, the speedometer shows 37 miles an hour and stays there when going down the road no matter how fast you driving.
Can any one set me straight oni am having a hard time understanding how I can mask off clear coat. I am not a painter but I know it can be pretty thick. Is soft edging a solution for clearing door jams and b pillars and stuff like that. Also can you do a sort of clear blend when I only want to paint half of a roof rail without having to go all the way down a quarter panel
The engine clicks, chugs but no turn over, lights, radio, and air all work fine.
when coming to a stop brake makes noise
Step 1: Find Noise When Brakes Applied
I accidentally pulled off the front and back bumper valance on my 06 Grand Prix. I know that I will need to replace the bolts on the sides and middle to keep it in place. I am having problems getting the plastic squares to lock into the bumper. I was wondering if there is a special process on how to do this or any guidance you could provide. I have put together a document with a diagram and some notes.
How do I find the fuses or relay serving the turn signals and hazard flashers in a 2003 Isuzu 2.5 TD pickup truck? I can't find them.
Which fuse do you replace for your windshield wipers in a Dodge Ram 2008.
Forum Thread: I Have a 03 Ford Focus 4cly the Timing Belt Tentioner Went the Belt Stayed Intact on Diss Asembally Discoverd Timing Was
is this one is one of those engines that if
This guy, originally a mechanic, built his own McLaren F1 from scratch... Hats off to him!