This video will show you how to check the oil level in a 2006-2010 Ford Explorer. This is easy to do and does not require any tools.
The engine oil capacity of a 2006-2010 Ford Explorer 4.0 V6 requires 5 quarts of 5W30 synthetic oil.
Forum Thread: How to Check Oil Level 2006-2010 Ford Explorer
- Hot
- Active
-
Forum Thread:
How to Replace 09-11 Ford Ranger Wheel Hub Bearing Assembly
0
Replies
4 yrs ago -
Forum Thread:
How to Change Spark Plug and Wires 2006-2010 Ford Explorer
0
Replies
4 yrs ago -
Forum Thread:
How to Replace 2006-2010 Ford Explorer Rear Lower Control Arm
0
Replies
4 yrs ago -
Forum Thread:
How to Replace Rear Brake Rotors and Pads 2011-2017 Honda Odyssey
0
Replies
4 yrs ago -
Forum Thread:
How to Replace Wiper Blades 2006-2010 Ford Explorer
0
Replies
4 yrs ago -
Forum Thread:
How to Change Spark Plugs 99-04 Jeep Grand Cherokee 4.0
0
Replies
4 yrs ago -
Forum Thread:
How to Change Oil 2000-2005 Cadillac DeVille
0
Replies
4 yrs ago -
Forum Thread:
How to Restore Headlight Lenses the Cheap Way
0
Replies
4 yrs ago -
Forum Thread:
How to Replace Windshield Wipers 2000-2005 Cadillac DeVille
0
Replies
4 yrs ago -
Forum Thread:
How to Use a Battery Load Tester
0
Replies
4 yrs ago -
Forum Thread:
Why Is My New Oil Filter Leaking
0
Replies
4 yrs ago -
Forum Thread:
How to Fix a Dent Using a Suction Cup
0
Replies
5 yrs ago -
Forum Thread:
What Is a Core Charge on Auto Parts
0
Replies
5 yrs ago -
Forum Thread:
Why Restoring Headlights Is a Waste of Time
0
Replies
5 yrs ago -
Forum Thread:
Why It Is Important to Service an Automatic Transmission
0
Replies
5 yrs ago -
Forum Thread:
How to Move a Ford Expedition That Is Stuck in Park
0
Replies
5 yrs ago -
Forum Thread:
How to Replace Jeep YJ Turn Signal Bulb
1
Replies
5 yrs ago -
Forum Thread:
How to Remove Jeep YJ Side Marker Light
0
Replies
5 yrs ago -
Forum Thread:
How to Replace Jeep YJ Side Marker Light Bulb
0
Replies
5 yrs ago
-
How To:
Open Your Car Door Without a Key: 6 Easy Ways to Get in When Locked Out
-
How to Fix Car Dents:
8 Easy Ways to Remove Dents Yourself Without Ruining the Paint
-
How To:
Replace and repair the rack and pinion on a Ford Escape or Mercury Mariner
-
How To:
Replace a thermostat on a GM 3.1L or 3.4L automobile
-
How To:
Unlock a Car Door Using a Cell Phone and a Faraway Keyless Remote (Faux-To?)
-
How To:
Replace the fuel filter in a Saturn S-Series car
-
How To:
Use Lysol to Clean Bacteria Out of Your Car's Air Conditioning System
-
How To:
Replace rear brake pads on a Ford Explorer
-
How To:
Clean your AC drain if water is spilling into your car
-
How To:
Reset a Busted Speedometer After Jump-Starting or Replacing a Vehicle's Battery
-
How To:
Get a Car Dent Out with a Pot & Vacuum Cleaner
-
How To:
Replace Headlight Bulb on Pontiac G6
-
How To:
Install a camshaft sensor and/or synchronizer on a 1998 Ford Windstar 3.0L
-
How To:
Repair the ABS & speed sensor in a Dodge Dakota truck
-
How To:
Adjust the curb idle speed on a Holley carb
-
How To:
Replace the Front Inside Door Handle on a 04-10 Toyota Sienna
-
How To:
Get a Dent Out of a Car Using Just a Plunger
-
Boiled Water:
The Easiest Way to Remove Dents from a Car Bumper
-
How To:
Fix a Huge Dent in Your Car at Home Without Ruining the Paint Job
-
How To:
Replace a 2009 Ford Focus brake, backup, or tail light bulb
1 Response
Hi
Thanks for sharing this video. I have shared with you some tips.
When you check be sure engine is off. Pull dipstick, wipe off, re-insert and then pull out again and check level. It helps you get a better reading. Once the dipstick is clean, insert it back in the tube.
Share Your Thoughts